HK blog

 In my last post I tried to simulate a site2site VPN connection using Wireguard via VyOS, my favourite router. It was very easy to implement but the performance was not that great on GNS3. It was not a VyOS issue at all, GNS3 is just a simulation tool and we can't expect real world performance in it, even if it uses Qemu and Linux virtual networking for that end. To prove that, I made the following simple iperf3 test using 3 VyOS routers on GNS3 : No VPN, just simple routing via connected routes through VyOS1.3-3. The result was similar to my Wireguard throughput test, of course considering the header size of Wireguard packets : In my Wireguard test, I reached a bitrate of 53.8 Mbps, which is almost 76% of total bandwidth, and it's a good result, but I had to verify if VyOS is able to route at a greater bitrate. For just that, I created a VyOS VM on VirtualBox and connected two other VyOS VMs to it's interfaces, and made an iperf3 test. The result was clearly better : Reach...

 This is something I had in mind but didn't find the time to accomplish before. It just took a very cold day to convince me that I have to play with Wireguard on VyOS. I used GNS3 of course, on my personal Linux laptop to create this setup. Of course the performance was not that great since it is just a simulation.  In real life, I am using Wireguard on a 10 years old Raspberry Pi Model B and amazingly with just a 700MHz single core ARM CPU and less than 512 MB of RAM I had a decent and stable permanent Wireguard tunnel. (My bandwidth would reach 24 Mbps without issue) Back to my simulation, this is what it looks like : Quick explanation: the VYOS routers labeled IPERF1 and IPERF2 are only used for an iperf3 test, which was able to reach about 50 to 60 Mbps each time. It ain't much but it was honest (and free) secure bandwidth! I won't get into the details of this setup but I will just post the two most important configurations : R-East and R-West : #### VYOS WireGuard Site...